Digital 2E1 PCI card OpenVox D230P

Digital 2E1 PCI card OpenVox D230P - economical modern digital PCI card with support of two E1 streams, it supports up to 64 channels in E1 stream or up to 48 channels in T1/J1 streams, it is characterized by productivity and high quality of voice transmission.

The OpenVox D230P board is an updated product of the D210P board and the most advanced dual-port digital card with high quality in the open source community. The modern digital dual-port E1 D230P board with a smart interrupt management system and a PCI interface is an inexpensive solution for connecting an office telephone station to high-quality communication channels. It supports up to 64 channels in an E1 stream or up to 48 channels in T1/J1 streams and is configured both for the board as a whole and for each port separately. A special feature of this model is the intelligent interrupt management system. This allows, firstly, to reduce the load on the central processor by up to 70%, and secondly, to avoid conflicts with other devices. The OpenVox D230P voice card also features high voice quality. The OpenVox D230P card works with Asterisk, Elastix, FreeSWITCH, PBX in a Flash, trixbox, Yate and IPPBX/IVR, as well as with Open Source PBX, Switch, IVR, and VoIP gateway applications. The OpenVox D230P is an economical solution for integrating an office IP PBX with digital communication lines - using similar gateways can cost several times more.
Applications: Voice over Internet Protocol (VoIP)IVR - pre-recorded voice messagesConference bridge allows a group of people to participate in a telephone conversationVoIP gateways (supports SIP, H.323, and IAX)Legacy PBX / IVR servicesVoice / Data Routing (replaces expensive routers)PRI/Switch compatible - network or CPE
Specifications: Dual T1/E1/J1 ports and PCI form factor for high performance voice and data applications Half-size PRI card RJ48 connector Low profile option 32-bit 33Mhz PCI and fully compatible with PCI 2.3 32-bit DMA host bus for 132MB/sec PCI data transfer Auto-sensing of 5V and 3.3V compatibility in PCI slot FPGA design, firmware upgradable from website Power: 2.3W minimum, 3.5W maximum on 3.3V or 5V Operating temperature: 0°C to 50°C Storage temperature: -65°C to 125°C Dimensions: 2U form factor: 12*6.4*1.8cm Weight: 92g