Digital 1E1 PCI card OpenVox D130P

Digital 1E1 PCI card OpenVox D130P is a cost-effective modern digital PCI card with support for one E1 stream, it supports up to 32 channels in the E1 stream or up to 24 channels in T1/J1 streams and provides high performance and voice transmission.

The OpenVox D130P board is an updated product of the D115P board and the most advanced single-port digital card with high quality in the open source community. The high-quality digital OpenVox D130P board supports up to 32 channels in the E1 stream or up to 24 channels in the T1/J1 streams and is configured both for the board as a whole and for each port separately. The OpenVox D130P voice board is an inexpensive solution for connecting an office telephone station to high-quality communication channels. A special feature of this model is the intelligent interrupt management system. This allows, firstly, to reduce the load on the central processor by 70%, and secondly, to avoid conflicts with other devices. The D130P model also has a slot for installing an additional OpenVox EC2032 echo cancellation module. The OpenVox D130P board works with Asterisk, Elastix, FreeSWITCH, Flash PBX, Trixbox, Yacht and IPPBX/IVR projects, as well as other Open Source gateway and PBX applications, switches, IVR and VoIP. OpenVox D130P is an economical solution for integrating an office IP PBX with digital communication lines - using similar gateways can cost several times more.
Applications: Voice over Internet Protocol (VoIP) Services Complex IVR Trees Meet-Me Conference Bridge Calling Card Platforms VoIP Gateways (support SIP, H.323, and IAX) Legacy PBX / IVR Services Voice / Data Router (replace expensive routers) PRI / Switch Compatibility - Network or CPE
Specifications: Single T1/E1/J1 ports with PCI interface for high-performance voice and data PRI belt card RJ48 connector Low profile option 32 bit 33 MHz PCI and fully PCI 2.3 compliant 32 bit master DMA data bus transfers over PCI interface at 132 MB/s AutoSense compatible with 5 V and 3.3 V PCI buses FPGA design, with field firmware expansion capability Power: 2.1W Minimum, 3.1W Maximum on 3.3 V or 5 V Operating Temperature: 0 ° C to 50 ° C Storage Temperature: -65 ° C to 125 ° C Dimensions: 2U Form Factor: 12 * 6.4 * 1.8 cm Weight: 90 g